Hi guys,
I am building an old school chop and I have a five-speed left-side drive trannie. Here in Cape Town, South Africa, I have to make everything myself (the Harley shops are expensive and don't stock this kind of part) and I desperately need a drawing with measurements, of the trannie mount plate (five-speed softail no offset left side drive) that goes onto the frame trannie mounts. Mounts are the same as the plans by Gary. Anybody got such a drawing available? It is the last item I need and my build will be ready for mock-up. Please mail to henrid@mweb.co.za if you'd be so kind.
Would really appreciate it.
Best wishes to all the builders out there.
Henri du Plessis
ChopperHandbook Forum
THE DISCUSSION SIDE OF THE DOT COM SITE! HTTP://CHOPPERHANDBOOK.COM Fill out your profile when you register.
Transmission mount plate
2 posts
• Page 1 of 1
Transmission mount plate
by Henri » Mon Jul 26, 2010 10:47 am
- Henri
- Newb
- Posts: 1
- Joined: Sat Sep 19, 2009 8:28 am
Re: Transmission mount plate
by Yona » Thu Jul 29, 2010 3:42 pm
Is this the one..?
You do not have the required permissions to view the files attached to this post.
Don't poke a bear with a short stick!
I.D.G.A.F.H.T.D.I.A.O.C.C.
I only work on scoots I like,When I feel like it,If it pays enough!
I hear ya'll have 2 village idiots, ..where's the other one?
If ya get a s#@t sandwich.......just eat the crust!!
I.D.G.A.F.H.T.D.I.A.O.C.C.
I only work on scoots I like,When I feel like it,If it pays enough!
I hear ya'll have 2 village idiots, ..where's the other one?
If ya get a s#@t sandwich.......just eat the crust!!
-
Yona - Contributor
- Posts: 651
- Joined: Fri Dec 15, 2006 7:20 am
- Location: Baja Georgia-Jax,Fla
2 posts
• Page 1 of 1
Return to Motors, Transmissions and Drive Systems
Who is online
Users browsing this forum: No registered users and 1 guest